Spectracom SecureSync 1200 User Reference Manual page 511

Command
options
oscget
portget
portset
portstate
ppsctrl
priorset
radius setretry
radius getretry
radius server list
radius server
add
radius server del
reboot
reftable
release4
release6
renew4
renew6
resetpw
routes4
routes6
rt4add
rt4del
rt4get
rt6add
SecureSync User Reference Guide
Displays configured options installed (if any)
Displays the installed system oscillator
Display whether network port is enabled (for example, "portget ETH2")
Enable or disable a network port:
"portset x on" where "x" is the port number (for example, "ETH2")
"portset X off"
[NOTE: Available since Web UI Revision no. 5.1.2]
Display the current state for a network port
Enable/disable individual 1PPS output signals
Sets the priority of an entry in the reference priority table
<value> Sets how many radius login retries will be attempted
<value> Gets the number of radius login retry attempts
Lists radius servers
<host> <port> <key> <timeout>
Adds radius server
<id> Deletes radius server number <id>
Used to warm-boot the unit without having to disconnect or reconnect power
Displays reference priority table
Used with DHCP to release the IPv4 address
Used with DHCPv6 to release the IPv6 address
Used with DHCP to renew the assigned IPv4 address
Used with DHCPv6 to renew the assigned IPv6 address
Resets the administrator account (spadmin) password back to the default value
" "
admin123
Displays the current IPv4 routing table(s)
Displays the current IPv6 routing table(s)
Adds an IPv4 static route
Deletes an IPv4 static route
Displays the configured IPv4 static routes
Adds an IPv6 static route
Description
APPENDIX
495