Spectracom SecureSync 1200 User Reference Manual page 191

For more information about the GNSS Survey , see "Deleting the GNSS Receiver Position" on
page 180.
For more information on Receiver Modes , see "Selecting a GNSS Receiver Mode" on
page 172.
Available GNSS Receiver Dynamics Settings
The following Receiver Dynamics settings are available:
The following table illustrates the interdependence between Receiver Dynamics, Receiver Mode
(see "Selecting a GNSS Receiver Mode" on page 172) and receiver type:
Table 3-2:
Single Satellite
Standard
Mobile (with u-blox receivers)
CHAPTER •
3 SecureSync User Reference Guide Rev. 23
Caution: If you select a setting that does NOT resurvey, and subsequently relocate
your unit (antenna) by more than 100 m,
will NOT detect the new position, and hence provide an incorrect time.
Land (Resurvey) : [default]
When used with the Mobile Receiver Mode, the receiver is adjusted for typical dynamic
land-based applications.
When used with the Standard Receiver Mode, this setting also will automatically initiate
a resurvey after SecureSync reboots, in order to account for a possible relocation.
Sea : The receiver dynamics will be optimized for mobile motion patterns typical with
marine applications, resulting in greater timing accuracy, and avoiding premature loss
of synchronization.
Air : The receiver dynamics will be optimized for acceleration forces typically exper
ienced in civil aviation applications.
Stationary (No Resurvey) : In Standard Mode, the receiver is set to a non-dynamic value
for stationary applications.
There will be no automatic resurvey after a reboot. Should a unit be relocated, you
need to delete its position, thus initiating a new survey.
Receiver dynamics, ~modes, ~ dynamics, ~ types
Receiver Mode
(Resurvey)
irrelevant
u-blox M8T
Receiver Dynamics
Land
Sea Air
irrelevant irrelevant
3.3 Managing References
and Trimble Res-T receivers
Stationary
(No Resurvey)
irrelevant
175