Has Timekeeper Been Activated - Spectracom SecureSync 1200 User Reference Manual

Getting started with TimeKeeper:
1.
2.
3.
3.6.2

Has TimeKeeper been activated?

FSMLabs' TimeKeeper module comes pre-installed with every SecureSync System Software Ver
sions 5.2.0 or higher.
The TimeKeeper license must be activated by applying a
from Spectracom, either at the time when a SecureSync unit is ordered, or later. For more
information, see "Applying a License File" on page 304.
To find out if the Timekeeper license on your SecureSync has been activated:
1.
2.
If a TimeKeeper License is installed, you will also notice that the right button in the Main Nav
igation bar is labeled MONITORING (not HELP), and under MANAGEMENT > NETWORK ,
there is a PTP Setup option available:
Next, make sure that TimeKeeper is turned ON: see "En-/Disabling TimeKeeper" on page 210.
CHAPTER •
3 SecureSync User Reference Guide Rev. 23
If the TimeKeeper license has been purchased separately, activate TimeKeeper by apply
ing the License file—see "Applying a License File" on page 304. (You can skip this step,
if the license was purchased with the SecureSync unit: In this case the License file will be
installed in the factory.)
Enable TimeKeeper—see "En-/Disabling TimeKeeper" on page 210.
Configure TimeKeeper, see "Configuring a TimeKeeper PTP Master" on the next page,
"Configuring TimeKeeper PTP Slaves" on page 206, and/or "Configuring TimeKeeper
as an NTP Time Server" on page 209.
In the Web UI, Select TOOLS > Upgrade/Backup .
In the System Configuration Panel, check the bottom row, under Option :
a.
OPT-TKL TimeKeeper
license key has been purchased and applied.
b.
If there is no entry under Option , the TimeKeeper license has not been activated.
License File
means that the TimeKeeper license has been activated, i.e. the
3.6 Managing TimeKeeper
, which can be purchased
203