Connecting The Line Network To The Patch Panel; Figure 4-86 Layout Of The Patch Panel S30807-K6143-X For Different - Siemens HiPath 3000 Service Manual

inst_h3.fm
Installing HiPath 3000
Installing HiPath 3750, HiPath 3700
4.3.4.8

Connecting the Line Network to the Patch Panel

Danger
7
Connect the system to ground before connecting the stations.
Telephones and trunks are connected directly to the MW8 jacks on the front of the patch panel.
Information on MW8 jack assignment on the front of the patch panel is provided in the board
descriptions (in the "Cable and Connector Assignment" table) in Chapter 3.
If you jumper stations on the patch panel (for example, with an ICCS network) with-
>
out first entering the relocate code, when you reconnect them the stations affected
will go into operation with the data of the stations originally installed.
1 3 5 7 9
2 4 6 8 10
SLA16N, SLC16, SLC16N
1 3 5 7 9
2 4 6 8 10
1 3 5 7 9
2 4 6 8 10
SLA16N, SLC16, SLC16N
Figure 4-86 Layout of the Patch Panel S30807-K6143-X for Different Peripheral Boards
4-150
Front panel with 3 x 16 MW8 jacks each
11 13 15 17 19 21
12 14 16 18 20 22
11 13 15 17 19 21
12 14 16 18 20 22
SLA24N
11 13 15 17 19 21
12 14 16 18 20 22
23 25 27 29 31 33
24 26 28 30 32 34
SLA16N, SLC16, SLC16N
23 25 27 29 31 33
24 26 28 30 32 34
SLA16N, SLC16, SLC16N
23 25 27 29 31 33
24 26 28 30 32 34
SLA24N
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
35 37 39 41 43 45 47
36 38 40 42 44 46 48
35 37 39 41 43 45 47
36 38 40 42 44 46 48
35 37 39 41 43 45 47
36 38 40 42 44 46 48
P31003-H3550-S403-4-7620, 02/05