Connecting Workpoint Clients; Making Trunk Connections; Performing A Visual Inspection - Siemens HiPath 3000 Service Manual

Hide thumbs Also See for HiPath 3000:

Table of Contents

Installing HiPath 3000

Installing HiPath 3550, HiPath 3350, HiPath 3500, and HiPath 3300

Connecting Workpoint Clients

For information, see Chapter 10.

Refer to the following board descriptions for information:

trunk connection)

TS2R, only HiPath 3500 (S

TLA4R (Not for U.S.) (MSI)

TMGL4R (for U.S. only)

TST1 (for U.S. only), HiPath 3500 only

Before starting up the system, you must perform a visual inspection of the hardware, cables,

and the power supply. The visual inspection must be performed while the system is disconnect-

ed from the power supply.

Conduct the visual inspection only while the system is disconnected from the power

Always wear an antistatic wristband and observe the measures for protecting elec-

trostatically sensitive devices (see Page 1-9).

Compare the slots for the

installed boards with the

board assignment map.

Check the local line voltage. Digital multimeter

After finishing the visual inspection, you can begin starting up the system as de-

scribed in Chapter 5.

trunk connection)

Board assignment map

Resources/Remarks

P31003-H3550-S403-4-7620, 02/05

HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual

Possible remedies

Correct the board

configuration and no-

tify the sales depart-

Table of Contents