Mounting The System Cabinet In The 19-Inch Cabinet; Removing The Cabinet Covers - Siemens HiPath 3000 Service Manual

Hide thumbs Also See for HiPath 3000:

Table of Contents

Mounting the System Cabinet in the 19-Inch Cabinet

A fully equipped HiPath 3700 cabinet weighs 22 kg (48.46 lb). We recommend lifting

cabinets only before they are equipped. Do not attempt to lift objects that you think

are too heavy for you; use a hand truck or get assistance.

Introduction

You can install up to three system cabinets in a 19-inch cabinet. Each cabinet must be mounted

It is only possible to extend the HiPath 3700 to a three cabinet system if the 19-inch cabinets

are next to one another and accessible from the back.

Cabinets are supplied fitted with the specific boards required by the customer.

Be sure to ground the system properly before starting it up and connecting the sta-

How the covers are secured

The front cabinet cover (for board servicing) and the rear cabinet cover (for cable servicing) are

each secured by two snap fasteners.

You can remove the upper and lower grills on both covers. This allows the cables to be routed

to the patch panel for example.

To replace a cover, position the snap fasteners in the two guides and press down on the cover

until it snaps into place.

P31003-H3550-S403-4-7620, 02/05

HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual

Installing HiPath 3000

Installing HiPath 3750, HiPath 3700

Table of Contents