Introduction - Siemens HiPath 3000 Service Manual

Hide thumbs Also See for HiPath 3000:

Table of Contents

HiPath Cordless Office

Introduction

Introduction

For HiPath 3000 V1.2 and later, HiPath Cordless Office can be used on all systems of this prod-

Direct connection

The BS3/1 (S30807-H5482-X) and BS4 (S30807-U5491-X) base stations can be connected di-

rectly to the U

interfaces on the central control boards in the HiPath 3550, HiPath 3350, Hi-

Path 3500, and HiPath 3300. The connection must be made via one U

mix of base stations of types BS3/1 and BS4 is supported.

A BS3/S (X30807-X5482-X100) single-cell base station can be used to ensure the operation of

a maximum of one base station at the U

3550, HiPath 3350, HiPath 3500, and HiPath 3300. In this case, it is not possible to expand with

additional base stations.

However, base stations cannot be simultaneously connected to the SLC16/SLC16N board and

the CBCC within one HiPath 3550 system.

Connecting cordless boards

Base stations can be connected to the U

in HiPath 3800

A mix of base stations of types BS2/2 (S30807-H5471-X200), BS3/1 (S30807-H5482-X), BS3/

3 (S30807-H5485-X), and BS4 (S30807-U5491-X) may be used on the above cordless boards.

You can install up to four SLC16 or SLC16N boards in HiPath 3750 and HiPath 3700 and up to

four SLCN boards in HiPath 3800. All four boards provide full cordless functionality (roaming

and seamless connection handover) because the radio fields on the cordless boards are syn-

chronized within a single system (see Section 11.6).

SLC16 and SLC16N can be used in mixed mode within a HiPath 3750 and HiPath 3700.

The HiPath 3000 product line does not currently support the network-wide handover feature.

interfaces on central control boards in the HiPath

in HiPath 3750, HiPath 3550 and HiPath 3700.

interfaces of the following cordless boards:

P31003-H3550-S403-4-7620, 02/05

HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual

interface each. A

Table of Contents