Starting Hipath 3300 As A Gateway; Prerequisites; Procedure For Installation And Startup; Table 7-4 Hipath 3300 As A Gateway - Procedure For System Installation And - Siemens HiPath 3000 Service Manual

start_3g.fm
Starting HiPath 3000 as a Gateway

Starting HiPath 3300 as a Gateway

7.6 Starting HiPath 3300 as a Gateway
7.6.1

Prerequisites

Warning
7
Only authorized service personnel should install and start up the system.
Refer to Section 4.4.1 for information on the tools and resources needed to install the HiPath
3300 system.
7.6.2

Procedure for Installation and Startup

To ensure that IP addresses are not assigned more than once in the customer net-
>
work, you must ping each new IP address to be configured before each IP address
is assigned. If an IP address responds, then this address cannot be used again.
Table 7-4 HiPath 3300 as a Gateway - Procedure for System Installation and Startup
Step
HiPath 3300 Installation (19-Inch Cabinet) (Section 4.4)
1. Selecting the Installation Site, page 4-187 (usually predetermined)
2. Unpacking the Components, page 4-188
3. Not for U.S.: Attaching a HiPath 3500 and HiPath 3300 to the Wall, page 4-189
4. Installing a HiPath 3500 or HiPath 3300 in a Cabinet, page 4-190
5. Grounding the System, page 4-192
6. Connecting Cables and the Line Network, page 4-194
7. Configuration notes, page 4-195
8. Making trunk connections
Refer to the following board descriptions for information:
STLS4R - for S
●
Note: Analog workpoint clients can be connected to the CBRC's T/R ports in emer-
gencies. This ensures telephone operation via the telecommunications network in
the event of IP network failure.
9. Making IP connections
Perform the IP connection over the HG 1500 board HXGR3.
For information on startup and configuration, refer to the HG 1500 Administration
Manual.
7-8
Activity (Remarks)
trunk connection
0
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
P31003-H3550-S403-4-7620, 02/05