Connecting The Cable To The Backplane - Siemens HiPath 3000 Service Manual

Hide thumbs Also See for HiPath 3000:

Table of Contents

Connecting the Cable to the Backplane

All cables that leave the system cabinet must be attached to the metal back panel

using cable ties.

Connection options

Peripheral devices can be connected up to the HiPath 3800 in a number of different ways:

SIVAPAC connector on the backplane for connecting the external main distribution frame

via CABLUs (prefabricated cabling units) or for connecting external patch panels (see

Section 4.2.6.4).

Connector panels with RJ45 jacks for direct connection of peripherals (see

Section 4.2.6.5). The connector panels are clipped onto the SIVAPAC connectors on the

For U.S. Only: Connector panels with CHAMP jack for direct connection of peripherals (see

Section 4.2.6.6). The connector panels are clipped onto the SIVAPAC connectors on the

Connector panels each with two SIPAC 1 SU connectors for connecting the external mail

distribution frame MDFU-E or external patch panels using CABLUs (see Section 4.2.6.7).

The connector panels are clipped onto the SIVAPAC connectors on the backplane.

The type of connection used will be decided in consultation with the customer on conclusion of

the agreement. The cabinets will be delivered accordingly with or without clipped-on connector

Be sure to connect the main protective earthing terminal on all system cabinets to

the grounding point of the electrical building installation before connecting up the pe-

ripherals (for example, potential equalization bus).

The system may only be started (connected to the power supply) if all system cabi-

nets are sealed at the rear with the connection and filler panels provided.

P31003-H3550-S403-4-7620, 02/05

HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual

Installing HiPath 3000

Installing HiPath 3800

Table of Contents