Siemens HiPath 3000 Service Manual page 610

Hide thumbs Also See for HiPath 3000:

Table of Contents

Installing HiPath 3000

Installing HiPath 3550, HiPath 3350, HiPath 3500, and HiPath 3300

Digital and analog trunks and subscriber lines from HiPath 3550 (wall housing)

The accessory pack does not contain enough ferrite sleeves for all trunks and sub-

scriber lines possible in a maximum system configuration. In this case, you will need

to order additional ferrite.

Trunk board or

Guide both standard cables from SU X8 and SU X9 (see Figure 4-99) to the

subscriber line

MDFU through two ferrite sleeves (C39022-Z7000-C7) each. The ferrite

modules in Hi-

should be placed as far inside the housing as possible.

Path 3750 for-

Trunk or sub-

Guide the trunk and subscriber lines of all ports connected on a board

scriber line

through a ferrite sleeve twice, i.e. in a loop. The ferrite should be fixed in the

cable duct if possible. If the number of lines makes this impossible, the ferrite

"small" format

can be attached directly at the output of the cable duct.

P31003-H3550-S403-4-7620, 02/05

HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual

Chapters

Table of Contents