Selecting The Installation Site; For U.s. Only: Ac Outlet; Unpacking The Components; Table 4-14 Electrical Connection Values (For U.s. Only) - Siemens HiPath 3000 Service Manual

inst_h3.fm
Installing HiPath 3000
Installing HiPath 3750, HiPath 3700
4.3.4.1

Selecting the Installation Site

The installation site is generally determined by the 19-inch cabinet already installed.
The environmental conditions specified in the system data chapter should also be taken into
consideration in this case (Section 2.9).
Information on the design of the HiPath 3700 can be found in Section 2.2.2.5.
4.3.4.1.1

For U.S. only: AC outlet

An AC connection is required for each cabinet. The AC connection must fulfill the requirements
specified in Table 4-14.
Table 4-14 Electrical Connection Values (for U.S. only)
Nominal Nominal voltage range
voltage
from
120 V AC/ 110 V AC
60 Hz
The system must be properly grounded before startup (see description in Section 4.3.4.5).
4.3.4.2

Unpacking the Components

Procedure
Step
1. Compare the components with the packing slip or customer receipt to make sure
that they are correct and complete.
2. Determine whether any damage has occurred during transport and report it to the
proper departments.
3. Dispose of the packing materials properly.
Caution
7
Only use tools and equipment that are in perfect condition. Do not use equipment
with visible damage.
4-128
Nominal Frequency
to from
130 V AC 47 Hz
Range
to
63 Hz
Activity
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
Wall Outlet Configura-
tions
NEMA 5-15, 2-pin, 3-
wire, earth