Siemens HiPath 3000 Service Manual page 940

service.fm
Service
Service and Maintenance Tasks
The next procedure depends on customer specifications:
The IP workpoint clients in the Small Remote Sites (branches) should use the same call
●
numbers in normal mode (registered with HiPath 4000) and in emergency mode (regis-
tered with HiPath 3000).
In this case, the call numbers are assigned via HiPath User Management.
When configuring the IP workpoint clients (system clients) via HiPath 3000 Manager E their
call numbers should be deleted. Otherwise it is not possible to assign call numbers via Hi-
Path User Management without taking further steps.
The IP workpoint clients in the Small Remote Sites (branches) should use different call
●
numbers in normal mode (registered with HiPath 4000) and in emergency mode (regis-
tered with HiPath 3000).
In this case, the call numbers are assigned via HiPath 3000 Manager E when configuring
the IP workpoint clients (system clients).
An IP workpoint client configured in this way can then be assigned a HiPath 4000 call num-
ber for normal mode via HiPath User Management.
The following configuration data for an IP workpoint client is modified via HiPath User Manage-
ment:
Internal call number
●
DID number
●
Directory name
●
CFSS destination
●
Access groups
●
Refer to the HiPath User Management service and administrator documentation for
>
information on the installation and configuration procedures for HiPath 3000/5000
and HiPath 3000 Element Manager.
12-22
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual