For U.s. Only: Connecting Peripherals To The Connector Panels With; Champ Jack; Figure 4-34 Hipath 3800 - Connector Panel With Champ Jack (For U.s. Only) - Siemens HiPath 3000 Service Manual

4.2.6.6 For U.S. only: Connecting Peripherals to the Connector Panels with CHAMP
Jack
The boards should be installed in the cabinets as described in Section 4.2.5. The S30807-
Q6626-X connector panels attached to the SIVAPAC connectors on the backplane are
equipped with a CHAMP jack.
Figure 4-34 HiPath 3800 - Connector Panel with CHAMP Jack (for U.S. only)
Danger
7
Be sure to connect the main protective earthing terminal on all system cabinets to
the grounding point of the electrical building installation before connecting up the pe-
ripherals (for example, potential equalization bus).
The system may only be started (connected to the power supply) if all system cabi-
nets are sealed at the rear with the connection and filler panels provided.
Connect the peripheral directly to the CHAMP jack in the connector panels.
If
Slot with periph- A cable with CHAP jack should be used to connect to a main distributor
eral card frame or external patch panel.
No assignment The backplane sections with empty board slots must be covered with filler
panels.
Information on cable and connector assignment is provided in the board descriptions in
Chapter 3.
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
Installing HiPath 3000
Installing HiPath 3800
Then
inst_h3.fm
4-61