Programming Add-On Devices - Siemens HiPath 3000 Service Manual

Hide thumbs Also See for HiPath 3000:

Table of Contents

Workpoint Clients

optiPoint 500

Programming Add-On Devices

An inserted add-on device automatically registers with the system and is then ready for opera-

tion. Keys can be programmed via HiPath 3000 Manager E or the respective telephone set. If

you replace the device, the information programmed under the keys is maintained (stored in the

customer database).

If a configuration other than the one shown in Figure 10-9 is used, the LEDs and keys may not

function correctly. You must update the database with HiPath 3000 Manager E.

Example: You replace configuration E by configuration B. You must use HiPath 3000 Manager

E to remove the optiPoint key module 2 from the database so that the LEDs and keys function

You can also use optiPoint BLF to delete Assistant Ts and optiPoint key modules.

The first optiPoint BLF that is initially connected to HiPath 3750, HiPath 3550, HiPath 3700, or

HiPath 3500 automatically receives standard key assignments (default) for the first 90 system

ports. No standard assignment is made if you already configured an optiPoint BLF with HiPath

3000 Manager E or if other optiPoint BLFs are connected.

Replacing an optiPoint key module with an optiPoint BLF

Unplug the connection cable between the optiPoint key module and the telephone

(or other optiPoint key module). Remove optiPoint key module.

Remove optiPoint key module from the database using HiPath 3000 Manager E.

Plug in the optiPoint BLF. HiPath 3000 Manager E automatically detects the BLF

and enters it in the database.

P31003-H3550-S403-4-7620, 02/05

HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual

Table of Contents