Siemens HiPath 3000 Service Manual page 268

boards.fm
Boards for HiPath 3000
Peripheral Boards
Configuring S interfaces
0
Depending on how the interfaces are applied, use HiPath 3000 Manager E to define the rele-
vant protocols for the trunks to be connected. Please note the additional information contained
in the protocol templates when selecting a suitable S
CO = Interfaces to the public CO
●
Bus = Interfaces to an internal station
●
Master = Interfaces for a master system network
●
Slave = Interfaces for a slave system network
●
H150/H118 or H300 = Defines the CorNet protocol:
●
– H150/H118 = Optimized for interconnection with HiPath 3000
This option should also be selected in connection with HiPath ProCenter Office HPCO.
– H300 = Optimized for interconnection with HiPath 4000
Direct or fixed connection: defines the type of connection for a network and controls the
●
supply of clock pulses:
– Direct = Communication systems are connected to one another by means of a direct
cable connection. The master system supplies the reference clock pulse for the net-
worked system.
– Fixed connection = Communication systems are connected over lines leased from a
network provider (with clock pulse supply). The master system receives the reference
clock pulse from the network.
A slave system always receives the clock pulse from the master system regardless of
whether the connection is direct or fixed.
Use the S interface S
0
also connect S interfaces S
0
group 4 fax device, PC, dialing aid) via an S
3-202
1 for connection to the public telecommunications network. You can
0
2 to S 4 to the ISDN trunk or to ISDN terminals (ISDN telephone,
0 0
protocol:
0
bus.
0
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
P31003-H3550-S403-4-7620, 02/05