Carrying Out A System Reload - Siemens HiPath 3000 Service Manual

Hide thumbs Also See for HiPath 3000:

Table of Contents

Starting Up HiPath 3000

Starting Up HiPath 3800

Carrying Out a System Reload

After supplying the system with power, you must carry out a system reload.

The reset/reload switch is tested by a Field Programmable Gate Array (FPGA). This

FPGA is loaded by the processor when starting up the HiPath 3800 and is only fully

functional after the loading process is complete. If the reset/reload switch is activated

during loading, then it is not possible to evaluate the cause of the restart. For this

reason, the reset/reload switch may only be activated after the system startup (green

Run LED lights up).

Press and hold down the reset switch for at least 5 seconds (FAIL LED (red) goes out). If you

do not hold down the reset switch for a full 5 seconds, the system may perform a reset rather

than a reload or may not reload properly.

P31003-H3550-S403-4-7620, 02/05

HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual

Table of Contents