Siemens HiPath 3000 Service Manual page 259

Connecting ISDN (S
You can use the MW jacks on the STLS boards to connect between one and four ISDN S
es. The interfaces on the STLS boards are freely configurable.
EURO CO point-to-point
●
EURO CO point-to-multipoint
●
EURO bus
●
CorNet N/CorNet NQ slave
●
Using HiPath 3000 Manager E, you can also set up configurations for networking and ded-
●
icated lines
Use the S interface S
0
You can also connect S
telephone, group 4 fax device, PC, dialing aid) via an S
The connection (networking) to HiPath 3000 and HiPath 4000 (CorNet NQ) can also be set up
via S interfaces S
0 0
S connection options:
0
Point-to-point (PP) (default)
●
Point-to-multipoint (PMP)
●
Connecting an ISDN trunk (not for U.S.)
Insert the connection cable supplied in jacks S
carrier.
Networking connection (HiPath 4000/CorNet NQ (not for U.S.)
Insert the connection cable supplied in jacks S
4000 port.
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
) interfaces (not for U.S.)
0
1 for connection to the public telecommunications network (ISDN trunk).
0
interfaces S 2 to S
0 0
1 to S 4.
0
4 to the ISDN trunk or to ISDN terminals (ISDN
0
bus.
0
1 to S 4. Insert the other end in the NT of the
0 0
1 to S 4. Connect the other end with the HiPath
0 0
boards.fm
Boards for HiPath 3000
Peripheral Boards
0
3-193
bus-