Optipoint 400, Optipoint 410, Optipoint 420, Optipoint 600 Office - Siemens HiPath 3000 Service Manual

portnos.fm
IP Protocols and Port Numbers Used with HiPath 3000/5000 V5.0

optiPoint 400, optiPoint 410, optiPoint 420, optiPoint 600 office

C.7 optiPoint 400, optiPoint 410, optiPoint 420, optiPoint 600 office
The workpoint clients support the flexible configuration (Flexible Port Numbering) of each TCP
and UDP port number, with the exception of:
SNMP
●
SNTP
●
DNS
●
WAP Push
●
WAP Push secure
●
The following table shows the configurable port numbers and their output parameters. The Port
Base Number is used in some cases. The Port Base Number is the configurable port number,
not the port numbers derived from the Port Base Number.
Table C-7 optiPoint 400, optiPoint 410, optiPoint 420, optiPoint 600 office - Used IP Pro-
tocols and Port Numbers
Function
H.225.0 RAS Port Area
H.225.0 Call Signaling Port Area
H.245 TCP Channel Port Area (Lo-
cal)
H.245 TCP Channel Port Area (Re-
mote)
RTP Port Area (Local)
RTP Port Area (Remote)
RTCP Port Area (Local)
RTCP Port Area (Remote)
HTTP Hypertext Transport Protocol
HTTPS Secure Hypertext Transport
Protocol
SNMP
C-12
Default port
UDP TCP
1720
1720
1720
Any
5010,
5012,
5014,
5016
Any
5011,
5013,
5015,
5017
Any
8085
443
161
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
Note
The RTP port number is even-num-
bered. The RTCP port number is equiv-
alent to the RTP port number + 1.
5004 to 5007 are reserved by IANA.
The RTP port number is even-num-
bered. The RTCP port number is equiv-
alent to the RTP port number + 1.
5004 to 5007 are reserved by IANA.
Not configurable
P31003-H3550-S403-4-7620, 02/05