Connecting Peripherals To The Connector Panels With Rj45 Jacks; Figure 4-33 Hipath 3800 - Connector Panels With Rj45 Jacks - Siemens HiPath 3000 Service Manual

4.2.6.5

Connecting Peripherals to the Connector Panels with RJ45 Jacks

The boards should be installed in the cabinets as described in Section 4.2.5. The connector
panels plugged into the SIVAPAC connectors of the backplane are equipped with eight or 24
RJ45 jacks according to the relevant board.
Figure 4-33 HiPath 3800 - connector panels with RJ45 Jacks
Danger
7
Be sure to connect the main protective earthing terminal on all system cabinets to
the grounding point of the electrical building installation before connecting up the pe-
ripherals (for example, potential equalization bus).
The system may only be started (connected to the power supply) if all system cabi-
nets are sealed at the rear with the connection and filler panels provided.
Connect the peripheral directly to the 8-pin RJ45 jacks on the connector panels.
If
Slot with Connector panel with eight RJ45 jacks: S30807-Q6624-X
STMD3 The RJ45 jacks are configured with four wires. S
connected (1:1 cable). The receive and send lines should be switched for
trunk connections.
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
Connector panel with 24 RJ45 jacks
Connector panel with eight RJ45 jacks
8-pin RJ45 jack
8 1
Installing HiPath 3000
Installing HiPath 3800
Then
stations can be directly
0
inst_h3.fm
4-59