Ani4R (For Selected Countries Only); Figure 3-141 Ani4R (For Selected Countries Only) (S30807-Q6917-Z103) - Siemens HiPath 3000 Service Manual

Hide thumbs Also See for HiPath 3000:

Table of Contents

ANI4R (for selected countries only)

Introduction

The ANI4R (Automatic Number Identification Rack) board is responsible for receiving station

numbers modulated using the CPFSK method, demodulating them, and forwarding them to the

HiPath 3500 or HiPath 3300 base system. In V4.0 SMR-7 or later, the station name is analyzed

in addition to the call number and shown on the telephone display.

Each ANI4R module can serve four trunks. It contains the external trunk board hardware inter-

faces (TMGL4R) and the options bus interface.

If ANI4R is installed as option 1 or 2,

8 (slots 6 and 8 not available with HiPath 3300).

Figure 3-141

ANI4R (for selected countries only) (S30807-Q6917-Z103)

P31003-H3550-S403-4-7620, 02/05

HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual

X3 (10-pin MW10 jack)

board must be inserted in slot 4, 6 or

To OPALR, or previous option

Boards for HiPath 3000

Table of Contents