Removing The Cabinet Covers; Figure 4-48 Hipath 3750 - Removing The Front And Rear Covers - Siemens HiPath 3000 Service Manual

Hide thumbs Also See for HiPath 3000:

Table of Contents

Installing HiPath 3000

Installing HiPath 3750, HiPath 3700

Removing the Cabinet Covers

How the covers are secured

The front cabinet cover (for board servicing) and the rear cabinet cover (for cable servicing) are

each secured by two snap fasteners.

You can remove the upper and lower grills on both covers. This allows the cables to be routed

to the MDFU or MDFU-E for example.

To replace a cover, position the snap fasteners in the two guides and press down on the cover

until it snaps into place.

Procedure (Figure 4-48)

Insert a slotted screwdriver (with the blade vertical) into a recess (1).

Carefully swing the handle of the screwdriver toward the center of the cabinet (2)

until the fastener snaps out and the cover loosens.

Then insert the screwdriver in the second recess (3), loosen its snap fastener.

Mounting the cover

HiPath 3750 - Removing the Front and Rear Covers

P31003-H3550-S403-4-7620, 02/05

HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual

Table of Contents