Install Mdfu Or Mdfu-E (Not For Usa) - Siemens HiPath 3000 Service Manual

Hide thumbs Also See for HiPath 3000:

Table of Contents

Installing HiPath 3000

Installing HiPath 3750, HiPath 3700

Install MDFU or MDFU-E (not for USA)

Introduction

The following are used as main distribution frames:

MDFU-E, which is shipped with new systems (see Figure 4-71).

the MDFU (one MDFU unit per system cabinet), which was used for Hicom 150 E OfficePro

in Release 2.0 and earlier (see Figure 4-70).

Installation notes

The main distribution frame should be installed in the direct vicinity of the system (note length

of connection cable) and at eye level. Mount it on the wall according to the instructions that

came with it. The bag attached to the cover contains a drill template. It also contains the nec-

essary screws and wall anchors for attaching the MDF to the wall.

Procedure for wall mounting

Use the template to drill holes.

Insert the wall anchors and screw in the screws, leaving 5 mm projecting.

Remove the housing cover. Attach the main distributor frame to the brackets and

remove the packing protection covering.

Tighten the screws through the holes.

P31003-H3550-S403-4-7620, 02/05

HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual

Table of Contents