Link Aggregation; Example #1: Link Aggregation Configuration Example - D-Link DES-3226L User Manual

Link Aggregation

This section includes instructions on configuring Link Aggregation using the Command Line
Interface and the Graphical User Interface.
Link Aggregation
Link Aggregation (LAG) allows the switch to treat multiple physical links between two end-
points as a single logical link. All of the physical links in a given LAG must operate in full-
duplex mode at the same speed.
Link Aggregation can be used to directly connect two switches when the traffic between them
requires high bandwidth and reliability, or to provide a higher bandwidth connection to a
public network. LAG offers the following benefits:
•
Increased reliability and availability -- if one of the physical links in the LAG goes down,
traffic is dynamically and transparently reassigned to one of the other physical links.
•
Better use of physical resources -- traffic can be load-balanced across the physical links.
•
Increased bandwidth -- the aggregated physical links deliver higher bandwidth than each
individual link.
•
Incremental increase in bandwidth -- A physical upgrade could produce a 10-times
increase in bandwidth; LAG produces a two- or five-times increase, useful if only a small
increase is needed.
Management functions treat a LAG as if it were a single physical port.
You can include a LAG in a VLAN. You can configure more than one LAG for a given
switch.

Example #1: Link Aggregation Configuration Example

This section provides an example of configuring the software to support Link Aggregation
(LAG) to a server and to a Layer 2 switch.
Link Aggregation 67