Chapter 42 Link Aggregation Command List - D-Link DGS-3120-24PC Manual

®
xStack DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
Chapter 42 Link Aggregation Command
create link_aggregation group_id <value 1-32> {type [lacp | static]}
delete link_aggregation group_id <value 1-32>
config link_aggregation group_id <value 1-32> {master_port <port> | ports <portlist> | state
[enable | disable] | trap [enable | disable]}
config link_aggregation algorithm [mac_source | mac_destination | mac_source_dest |
ip_source | ip_destination | ip_source_dest | l4_src_port | l4_dest_port | l4_src_dest_port]
show link_aggregation {group_id <value 1-32> | algorithm}
config lacp_port <portlist> mode [active | passive]
show lacp_port <portlist>
42-1 create link_aggregation group_id
Description
This command is used to create a link aggregation group on the Switch.
Format
create link_aggregation group_id <value 1-32> {type [lacp | static]}
Parameters
group_id - Specify the group id. The number of link aggregation groups is project dependency.
The group number identifies each of the groups.
<value 1-32> - Enter the group ID value here. This value must be between 1 and 32.
type - (Optional) Specify the group type is belong to static or LACP. If type is not specified, the
default is static type.
lacp - Specify to use LACP as the group type.
static - Specify to use static as the group type.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create link aggregation group:
DGS-3120-24TC:admin# create link_aggregation group_id 1 type lacp
Command: create link_aggregation group_id 1 type lacp
Success.
DGS-3120-24TC:admin#
List
418