Table of Contents
Advertisement
4 Configuration
L2 Features > Link Aggregation
The Link Aggregation function enables the combining of two or more ports together to increase bandwidth.
Each Link Aggregation group supports a maximum of four ports.
The fields that can be configured for Link Aggregation are described below:
Item
Link Aggregation Global Settings
Link Aggregation
Channel Group Information
ID
Port
Click Apply to make the configurations take effect.
Click Delete to remove the Link Aggregation group.
L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping Settings
With Internet Group Management Protocol (IGMP) snooping, the Smart Managed Switch can make
intelligent multicast forwarding decisions by examining the contents of each frame's Layer 2 MAC header.
By default, IGMP is disabled. If enabled, the Smart Managed Switch can recognize IGMP queries and
reports sent between network stations or devices and an IGMP host. With IGMP snooping enabled, the
Smart Managed Switch will forward multicast traffic only to the connections that requested it.
Figure 4.41 – L2 Features > Link Aggregation
Description
Specify to enable or disable the Link Aggregation function.
Use the drop-down menu to select a link aggregation group.
Select the ports to assign to the aggregation group.
Table 4.25
NOTE: Maximum number of ports in a Link
Aggregation group is 4. DGS-1100-05V2/05PDV2
only supports 1 Link Aggregation group, and DGS-
1100-08V2/08PV2
supports
Aggregation groups.
NOTE: Each combined port must be connected to
devices within the same VLAN group.
3
3
3
3
D-Link Smart Managed Switch User Manual
up
to
2
Link
Advertisement
Table of Contents
