Verifying A Hybrid Link; Example Of Configuring A Hybrid Link On A Wan Interface; Configuring An Access Port On An Ethernet Interface - Avaya 2330 Manual

Verifying a hybrid link

Use the procedure in this section to verify the successful configuration of a hybrid link.
Procedure steps
1. To view information related to the interface mode, enter:
2. To view information related to the operation of the hybrid interface, enter:

Example of configuring a hybrid link on a WAN interface

Procedure steps
1. To access configuration mode, enter:
2. To select a bundle (in this example, the bundle identified as BRI1IF), enter:
3. To link the bundle to an interface (in this example, the interface is port 1 of the
4. To configure the encapsulation, enter:
5. To configure the interface as a Layer to interface, enter:
6. To configure the interface as a hybrid link, enter:

Configuring an access port on an Ethernet interface

Access ports belong to a single VLAN and do not provide any identifying marks on the frames
that are passed between devices. Access ports carry traffic that comes only from the VLAN
assigned to the port.
Configuration — Layer 2 Ethernet
no switchport
show bridge port
show interface bundle <bundle-name>
configure terminal
interface bundle BRI1IF
module in slot 3), enter:
link BRI 3/1
encapsulation ppp
switchport
switchport mode hybrid
Configuring an access port on an Ethernet interface
July 2013 99