unit
Configuring System Logging using ACLI
Configure the system settings for the system event log.
Procedure
1. Log on to ACLI in Global Configuration command mode.
2. At the command prompt, enter the following command:
Variable definitions
The following table describes the parameters for the logging command.
enable|disable
level critical|serious|informational|none
nv-level critical|serious|none
remote
volatile
Configuration — System Monitoring
Variable
[no] [default] logging [enable|disable] [level critical|
serious| informational|none] [nv-level critical|serious|
none] remote [address|enable|level] volatile [latch|
overwrite]
Variable
Value
Specifies the log messages for a certain
unit.
Value
Enables or disables the event log
DEFAULT: Enabled
Specifies the level of logging stored in
DRAM.
Specifies the level of logging stored in
NVRAM.
Configures remote logging parameters:
• Address: configure remote syslog address
• Enable: enable remote logging
• Level: configure remote logging level
Configures options for logging to DRAM.
• Latch: latch DRAM log after it is full
• Overwrite: overwrite DRAM log after it is
full
System logs using ACLI
March 2013
29