Chapter 11: Configuring SLA Monitor
Use the procedures in this chpater to configure SLA Monitor using either ACLI or Enterprise Device
Manager (EDM).
Configuring the SLA Monitor agent using ACLI
Use the procedures in this section to configure the SLA Monitor agent.
Displaying SLA Monitor agent settings
Use this procedure to view the global SLA Monitor agent settings.
Procedure
1. Log on to the Privileged EXEC command mode in ACLI.
2. At the command prompt, enter the following command:
Example
output to be added
Configuring the SLA Monitor
Use this procedure to configure the SLA Monitor agent to communicate with an SLA Monitor
server to perform QUality of Service (QoS) tests of the network.
Before you begin
To use the SLA Monitor agent, you must have an SLA Monitor server in your network.
About this task
To configure the agent, you must enable it and assign an IP address. By default, the agent
uses the switch/stack IP address for the SLA Monitor agent if a specific agent address is not
configured. Remaining agent parameters are optional and you can operate the agent using
the default values.
Troubleshooting 5.1
show application slamon agent
February 2013
79