Table of Contents
Advertisement
F
CONTROL SYSTEM
USE CONNECTOFI A
CRANK ANGLE SENSOR {lN OISTRIBUTOR)
Inspection
1. Bemove the drslnbutor. (Befer lo Seclion G.)
2. Connect the distributor conneclor as shown in the ligure.
3. Connect the high-tension lead.
4. Turn the ionition switch ON.
5. Connect the SSTS (Englne Signal Monitor and Adapt-
el) to the ECU as shown.
6. Set the SSTS (Engine Signal Monitor and Adapler) ter-
minal 2E.
7. Botate the distributor drive by hand and measure the ou!
put voltage.
Speclflcation
8. After the inspection, install the distributor.
(Refer to Section G.)
9. Stari the engine and adjust the ignition timlng.
(Reier io page F-63.)
lgnition iimlngr BTDC 16 + 10
0. Tighten the distributor lock bolts to the specified torque
Tighlening torque:
t6-23 N.m (1.6-2.3 m-kg, 12-16 tt'lb)
^- t:,?\
l ; - \ '
l , ! , - , :
ferminal
Tesl condition
Voltago
2E
Rorate distributor one lull lurn
Apprcx. 5V i4 pulses)
F-120
Advertisement
Table of Contents
Troubleshooting
