Removing The Sas Expander Board - Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual

10 Power cable
▶ Connect the power cable to the connector "PWR 4" on the system board.
▶ Connect the signal cable to the connector "SMB2" on the system board.
The cables are equipped with labels showing the right connector.
For the cable plan, see
CAUTION
Incorrect cabling may cause wrong LED identification of the HDD/SSD.
Misleading LED could lead to swapping out the wrong HDD/SSD, and
that will result in data loss.
▶
Check the correct cabling using the labels on the cables and the
cable plans.
Concluding steps
▶
"Installing the fan cage" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
7.7.2

Removing the SAS expander board

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
RX2540 M7
Hard disk drive (HDD) / solid state disk (SSD)
"Appendix B" on page
77.
59.
65.
71.
Upgrade and Maintenance Manual
559.
Hardware: 10 minutes
47.
71.
49.
207