Front Lan Connector; Installing The Front Lan Connector; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

13.2

Front LAN connector

13.2.1 Installing the front LAN connector

Field Replaceable Units (FRU)
Average task duration: 10 minutes

13.2.1.1 Required tools

Preliminary and concluding steps: tool-less
●
Installing the front LAN connector:
●
– Phillips PH2 / (+) No. 2 screw driver

13.2.1.2 Preliminary steps

Before installing the front LAN connector, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the desired server as described in section
server" on page
Ê Shut down the server as described in section
page 61.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Bring the server to its horizontal position.
TX140 S1
93.
61.
54.
"Disconnecting power cords" on page
"Extending the server out of the rack" on page
Upgrade and Maintenance Manual
Front panel and external connectors
"Locating the defective
"Shutting down the server" on
66.
"Disabling BitLocker
"Opening the rack
63.
65.
383