Front Lan Connector; Installing The Front Lan Connector; Required Tools; Preliminary Steps - Fujitsu PRIMERGY RX300 S7 Upgrade And Maintenance Manual

Front panel
13.3

Front LAN connector

13.3.1 Installing the front LAN connector

Field Replaceable Units (FRU)
Average task duration: 10 minutes

13.3.1.1 Required tools

Preliminary and concluding steps: tool-less
●
Installing the front LAN connector:
●
– Slotted screw driver for breaking out the front LAN cover plate
– Phillips PH2 / (+) No. 2 screw driver

13.3.1.2 Preliminary steps

Perform the following procedures:
"Disabling BitLocker functionality" on page 85
Ê
"Opening the rack door" on page 64
Ê
"Locating the defective server" on page 56
Ê
"Shutting down the server" on page 65
Ê
"Disconnecting power cords" on page 66
Ê
"Extending the server out of the rack" on page 69
Ê
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
"Removing the server cover" on page 72
Ê
"Removing the air duct" on page 73
Ê
"Removing the fan box" on page 183
Ê
426 Upgrade and Maintenance Manual
70.
RX300 S7