Removing Accessible Drives; Preliminary Steps; Removing An Accessible Drive - Fujitsu Server PRIMERGY TX1330 M1 Upgrade And Maintenance Manual

12.3

Removing accessible drives

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver (for removing the rack front cover)
Other procedures: tool-less

12.3.1 Preliminary steps

"Disabling BitLocker functionality" on page 69
Ê
"Locating the defective server" on page 43
Ê
"Removing backup and optical disk media" on page 72
Ê
"Verifying and configuring the backup software solution" on page 73
Ê
"Shutting down the server" on page 46
Ê
"Disconnecting the server from the mains" on page 46
Ê
"Getting access to the component" on page 47
Ê
"Removing the rack front cover" on page 52
Ê
front cover" on page 56
I
The front cover only needs to be removed in order to remove or install
accessible drive dummy covers.

12.3.2 Removing an accessible drive

Ê Disconnect all cables from the accessible drive.
Ê Press out on the locking latch to disengage the accessible drive locking bar
(see figure 146).
Ê Fold up the accessible drive locking bar.
TX1330 M1
(tower server)
Upgrade and Maintenance Manual
Accessible drives
Hardware: 10 minutes
(rack server) or "Removing the
241