Removing Accessible Drives - Fujitsu PRIMERGY TX2550 M4 Upgrade And Maintenance Manual

12.3

Removing accessible drives

Upgrade and Repair Unit
(URU)
Tools: tool-less
12.3.1 Preliminary steps
"Locating the defective server" on page 49
Ê
"Removing backup and optical disk media" on page 108
Ê
"Verifying and configuring the backup software solution" on page 109
Ê
"Shutting down the server" on page 52
Ê
"Disconnecting the power cord" on page 53
Ê
"Getting access to the component" on page 54
Ê
I
The front cover only needs to be removed in order to install
accessible drive dummy covers. If the accessible drive is replaced
after being removed, leave the front cover installed.
"Removing the system air duct" on page 67
Ê
Ê If applicable, "Removing the riser module" on page 84
Ê If applicable, remove the expansion card, see section
expansion card" on page
Ê Remove the fan bridge, see section
TX2550 M4
318.
"Handling fan bridges" on page
Upgrade and Maintenance Manual
Accessible drives
Hardware: 10 minutes
"Removing an
90.
385