Accessible drives
Ê When working on a rack-mounted server, secure it in the rack as described
in section
"Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
Ê Verify if your backup software solution requires additional configuration after
installing, removing or replacing an accessible drive as described in section
"Verifying and configuring the backup software solution" on page
12.3
Removing accessible drives
Upgrade and Repair Units (URU)
Average task duration: 10 minutes
12.3.1 Required tools
Preliminary and concluding steps: tool-less
●
Removing accessible drives: tool-less
●
12.3.2 Preliminary steps
Before removing an accessible drive, perform the following steps:
Ê Locate the desired server as described in section
server" on page
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section
page
142.
628
131.
62.
"Removing backup and optical disk media" on
Upgrade and Maintenance Manual
130.
128.
"Connecting the server to
"Locating the defective
TX300 S7 / RX350 S7
153.