12.3
Removing accessible drives
Upgrade and Repair Units (URU)
Average task duration: 10 minutes
12.3.1 Required tools
Preliminary and concluding steps:
●
– Phillips PH2 / (+) No. 2 screw driver
Removing accessible drives:
●
– Phillips PH2 / (+) No. 2 screw driver
12.3.2 Preliminary steps
Before removing an accessible drive, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the desired server as described in section
server" on page
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section
page
96.
Ê Verify if your backup software solution requires preparative configuration
before starting the procedure as described in section
configuring the backup software solution" on page
Ê Shut down the server as described in section
page
61.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
TX140 S1
93.
61.
54.
"Removing backup and optical disk media" on
"Disconnecting power cords" on page
Upgrade and Maintenance Manual
Accessible drives
"Disabling BitLocker
"Opening the rack
"Locating the defective
"Verifying and
96.
"Shutting down the server" on
63.
351