Installing Accessible Drives; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Accessible drives
12.2

Installing accessible drives

Upgrade and Repair Units (URU)
Average task duration: 10 minutes

12.2.1 Required tools

Preliminary and concluding steps:
●
– Phillips PH2 / (+) No. 2 screw driver
Installing accessible drives:
●
– Phillips PH2 / (+) No. 2 screw driver

12.2.2 Preliminary steps

Before installing an accessible drive, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê If applicable, open the rack door as described in section
door" on page
Ê Shut down the server as described in section
page 61.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Bring the server to its horizontal position.
330
93.
61.
"Disconnecting power cords" on page
"Extending the server out of the rack" on page
Upgrade and Maintenance Manual
"Disabling BitLocker
"Opening the rack
"Shutting down the server" on
66.
63.
65.
TX140 S1