Installing The Cpu And Heat Sink - Fujitsu PRIMERGY TX2550 M4 Upgrade And Maintenance Manual

Processor (CPU)
Figure 267: Applying thermal paste
Ê Apply a small streak of thermal paste (see description above) to the center
of the CPU surface as shown.
V
CAUTION!
Do not mix different types of thermal paste.

11.3.5 Installing the CPU and heat sink

Ê Confirm that the CPU model number printed on the top of the CPU fits with
the requirements.
Ê If applicable, remove the protective cap from the bottom side of the new
CPU.
Ê Install the CPU and heat sink, see section
on page 358.
11.3.6 Concluding steps
"Installing the system air duct" on page 68
Ê
"Reassembling" on page 68
Ê
"Connecting the power cord" on page 81
Ê
"Switching on the server" on page 82
Ê
370
Upgrade and Maintenance Manual
"Installing the CPU and heat sink"
TX2550 M4