Looking For The Mac Address Of A Lan Controller - Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual

Basic software procedures
Different controllers send different addresses:
– LAN controller: MAC (Media Access Control) address
– Fibre channel controller: WWN (World Wide Name) address
– Infiniband/Omni-Path controller: GUID (Globally Unique IDentifier) address
– SAS controller: SAS (Serial Attached SCSI) address
5.3.14.2

Looking for the MAC address of a LAN controller

There are several possible locations where these addresses can be found.
▶ Inform the customer about the new or changed MAC address.
Checking the label
▶ If available, check the label on the controller. Beside the part number, you
may find the MAC address.
Using the BIOS
▶ Enter the BIOS.
▶ Select the Configuration menu.
The addresses are displayed at the one or more of the following (it depends on
the behavior of the UEFI driver included in each controller).
1. The addresses are displayed at the UEFI driver menu included in each
controller in the Configuration menu.
2. Select the UEFI driver menu included in each controller. The addresses are
displayed at the help for the UEFI driver menu included in each controller.
3. Enter the Network Device List menu. The addresses are displayed in the
Network Device List menu.
Only network controllers supporting the Command Line Protocol (CLP)
will be displayed.
110 Upgrade and Maintenance Manual RX2540 M7