Table of Contents
Advertisement
9J-8 Hood / Fenders / Doors:
• Adjust door latch striker position by referring to "Rear
End Door Lock Assembly Removal and Installation in
Section 9F".
• Adjust door cushion so that door contacts body when
closed.
• Apply sealant to contact face "A" of door hinge (1) and
apply grease to rotating part "B" of hinge (1).
Specified sealant and grease.
"A": Sealant 99000–31110 (SUZUKI Bond
No.1215)
"B": Grease 99000–25011 (SUZUKI Super Grease
A)
Tightening Torque Specifications
Fastening part
Hood latch bolt
Rear end door balancer bolt
NOTE
The specified tightening torque is also described in the following.
"Front Door Assembly Components"
"Rear Door Assembly Components"
"Rear End Door Assembly Components"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fasteners Information in Section 0A".
Recommended Service Material
Material
Grease
Sealant
NOTE
Required service material is also described in the following.
"Front Door Assembly Components"
"Rear Door Assembly Components"
"Rear End Door Assembly Components"
I2RH019A1012-01
Specifications
Special Tools and Equipment
SUZUKI recommended product or Specification
SUZUKI Super Grease A
SUZUKI Bond No.1215
All Latches, Hinges and Locks Inspection
Doors
Check that each door of front, rear and back doors
opens and closes smoothly and locks securely when
closed.
If any malfunction is found, lubricate hinge and latch or
repair door lock system.
Engine Hood
Check that secondary latch operates properly (check
that secondary latch keeps hood from opening all the
way even when pulling hood release handle inside
vehicle.) Also check that hood opens and closes
smoothly and properly and hood locks securely when
closed.
If any malfunction is found, lubricate hinge and latch, or
repair hood lock system.
Tightening torque
N⋅m
kgf-m
10
1.0
23
2.3
P/No.: 99000–25011
P/No.: 99000–31110
S6RW0C9A06011
S6RW0C9A07001
Note
lb-ft
7.5
17.0
S6RW0C9A08001
Note
/
/
/
Advertisement
Chapters
Table of Contents
Troubleshooting
