Bearing Replacement Of Crankshaft - Honda CB HORNET 160R 2015 Shop Manual

CRANKCASE/TRANSMISSION/KICKSTARTER
Apply locking agent to the threads of the setting plate bolt.
Install the setting plates and bolts.
Install the setting plates and bolts.
Tighten the bolts to the specified torque.
TORQUE: 12 N.m (1.2 kgf. m, 9 Ibf.ft)
BEARING REPLACEMENT OF
CRANKSHAFT
INSPECTION
Turn the inner race of bearing with your finger.
The bearing should turn smoothly and quietly.
Also check that bearing outer races fit tightly in the
crankcase.
Replace bearing if the inner race do not turn smoothly,
quietly or if they loosely fit in crankcase (page 11-10).
REMOVAL
Drive out the crankshaft bearing from the right crankcase.
INSTALLATION
If the crankshaft bearing inner race is removed install it
as shown.
11-12
BOLTS/SETTING
STOPPER PLATES
CRANKSHAFT
BEARING
IN SIDE
INNER RACE