Set Nas-Interface - Fujitsu Eternus DX100 S3 User Manual

Chapter 7 NAS Function Setting and Display
7.2 Network Interface > set nas-interface

set nas-interface

This command changes NAS network interface settings. In the NAS interface definition, at least one valid IP
address (the "-ip" parameter, the "-link-local-ip" parameter, or the "-connect-ip" parameter) must be specified.
■ Syntax
set nas-interface -nas-if-number
[-port { port | ""}] [-rip {enable|disable}]
vlanid
[-vlan-id {
gateway_address
[-gateway {
[-link-local-ip {
[-subnet-prefix-length {
■ Parameter
-nas-if-number
-port
-rip
nas-if-number
ip_address
| "" | 0}] [-ip {
| "" | 0.0.0.0}]
link_local_address
| "" | ::}] [-connect-ip {
prefix_length
}] [-ipv6-gateway {
This parameter specifies one target NAS interface.
A NAS interface that does not exist cannot be specified.
nas-if-numbe
r
NAS interface number
Optional. This parameter specifies the port to which the NAS interface is to be assigned.
To delete a port, specify a null character ("").
• Only NAS ports can be specified.
• A port that is set as a member port for bonding cannot be specified.
• When VLANID is not specified, only one NAS interface can be assigned to each NAS port.
• When VLANID is specified, up to 160 NAS interfaces can be assigned to each NAS port.
port
Port to be assigned
Example: -port 100
"" The port to which the NAS interface is to be assigned is deleted.
Optional. This parameter specifies whether to receive routing information using the Routing
Information Protocol (RIP). The RIP supports receive processing, but does not support send
processing.
enable Routing information is received using RIP.
disable Routing information is not received using RIP
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
netmask
| "" | 0.0.0.0} -netmask {
ip_address
| "" | ::}]
gateway_address
755
| "" | 0}]
| "" | ::}]
P2X0-1210-05ENZ0