Show Host-Lu-Qos - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-lu-qos

show host-lu-qos

This command displays the detailed setting information for the Host-LU QoS function.
■
Syntax
show host-lu-qos [-mode {port-qos|host-qos|lu-qos}] [-port {xyz|all}]
[-host-type {fc|iscsi|sas} -host-number
[-lu-qos-group
■ Parameter
-mode
-port
-host-type
-host-number
or
-host-name
host_number
lu_qos_group_number ]
Optional. This parameter specifies which QoS settings are displayed.
port-qos Port QoS
host-qos Host QoS
lu-qos LU QoS
Optional. This parameter limits the QoS settings that are to be displayed to those that are
related to the specified port.
Example: -port 000
For details, refer to "1.2.15 Host Interface Port Syntax" (page
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the host
port number.
Example: "123" indicates CM#1-CA#2-Port#3
all All the host interface ports
Optional. This parameter specifies the type of host to set Host QoS for. The host can be
specified by using the "-host-number" or "-host-name" parameter. Only one host type can be
specified at the same time.
fc FC/FCoE
iscsi iSCSI
sas SAS
Optional. This parameter limits the QoS settings that are to be displayed to those that are
related to the specified host. The "-host-type" parameter must also be specified to use this
parameter. For details, refer to
host_number
Host number
host_name Host name
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
host_name
| -host-name
"1.2.11 Host Syntax" (page
377
]
29).
27).
P2X0-1210-05ENZ0