Chapter 7 NAS Function Setting and Display
7.5 Network Settings > set nas-port
-nfs
-rip
-icmp
■
Example(s)
The following example shows settings for assigning the transfer rate to "1Gbit/s Auto" and the MTU size to
"9000" for the NAS port at CM#0 CA#0 Port#0:
CLI> set nas-port -port 000 -mtu 9000 -rate 1gauto
Optional. This parameter specifies whether the NFS connection is enabled or disabled. If
omitted, this parameter is not changed. The default value is "open".
open
The NFS connection is enabled.
close
The NFS connection is disabled.
Optional. This parameter specifies whether the RIP connection is enabled or disabled. If
omitted, this parameter is not changed. The default value is "open".
open
The RIP connection is enabled.
close
The RIP connection is disabled.
Optional. This parameter specifies whether the ICMP connection is enabled or disabled. If
omitted, this parameter is not changed. The default value is "open".
open
The ICMP connection is enabled.
close
The ICMP connection is disabled.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
774
P2X0-1210-05ENZ0