Specifying A Port Group And Performing Lun Mapping; Specifying A Port And Setting Lun Mapping - Fujitsu Eternus DX100 S3 User Manual

Appendix D Basic Setting Examples
D.2 Settings for Various Host Accesses
D.2.2

Specifying a Port Group and Performing LUN Mapping

An example of setting up host access is shown below. For more details, refer to
Management" (page
The example shown below is the case for the Fibre Channel interface.
Procedure
1
Set the connection of host interface ports 000 and 100 to fabric.
The following example shows the case for the Fibre Channel interface.
CLI> set fc-parameters -port 000,100 -connect fabric
2
Group host interface ports 000 and 100 together, and create a port group named PG0001.
CLI> create port-group -name PG0001 -port 000,100
3
Map a volume with a LUN, and create a LUN group named LUN002.
CLI> create lun-group -name LUN002 -volume-name v2 -lun 0
In this example, volume v2 and LUN 0 are mapped.
4
Set the relationship between port group PG0001, LUN group LUN002, and host response
number 0.
CLI> set host-affinity -port-group-name PG0001 -lg-name LUN002 -host-response-number
D.2.3

Specifying a Port and Setting LUN Mapping

An example of creating host access is shown below. For more details, refer to
Management" (page
The example shown below is the case for the Fibre Channel interface.
Procedure
1
Disable the host affinity mode of host interface ports 000 and 001.
CLI> set fc-parameters -port 000,001 -host-affinity disable
2
Set the connection topology of host interface ports 000 and 001 to fabric.
CLI> set fc-parameters -port 000,001 -connect fabric
218).
218).
927
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
"3.5 Host Interface
0
End of procedure
"3.5 Host Interface
P2X0-1210-05ENZ0