Fujitsu Eternus DX100 S3 User Manual page 867

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
ED208
ED209
ED20B
ED20D
ED20E
ED20F
ED210
ED211
ED212
ED213
ED214
ED215
ED216
ED217
ED218
ED219
ED21A
ED21B
ED21C
The specified RAID Group is not in "Available" state.
The RAID group is not in Available status.
An error has occurred in a communication path.
An error has occurred in a communication path.
The source volume of migration is being deleted by internal process after completed migration.
The migration source Thin Provisioning Volume is internally being deleted after migration is complete.
Wait for a while and try again.
No response is received.
No response is received. Wait for a while and try again.
iSNS server is not set.
An iSNS server is not set.
The installation type information for the DE that is to be added is insufficient.
The installation type information for the DE that is to be added is insufficient. Check the input content or
the device status.
Maintenance mode start or maintenance mode end is being executed by operation.
Maintenance is being started or being terminated due to a Maintenance SW.
The license information is being updated because the trial license expired.
The license information is being updated because the trial license expired. Wait for a while and try again.
The Bitmap is being acquired.
The Bitmap is being acquired. Wait for a while and try again.
The storage is not in "Not Ready" state. Wait for a while and try again.
The ETERNUS DX is in Not Ready status. Check the device status.
The Not Ready factor is not Machine Down Recovery failed.
The cause of Not Ready status is not Machine Down Recovery Fail. Check the device status.
(if processing mode is 0x00) CM with the following status exists among defined CM: Status other than
Online - This CM is not included in the Cyclic composition.
The status of the CM is not Online or the CM is not included in the Cyclic configuration.
The device is a busy state. Please wait for a while.
Two internal processes are running. Wait for a while and try again.
Storage Cruiser is being used. The process was aborted.
A process (collecting performance information) that was started from Storage Cruiser is currently being
performed. Wait for a while and try again.
Command executed from except Storage Cruiser. The process was aborted.
A process (collecting performance information) that was started from software other than Storage Cruiser
is currently being performed. Wait for a while and try again.
Reading all BUDs failed.
Reading of all the BUDs failed. Wait for a while and try again.
No BUDs are accessible.
No BUDs are accessible. Wait for a while and try again.
Writing all BUDs failed.
Writing of all the BUDs failed. Wait for a while and try again.
All of the BUD capacity is used.
All of the BUD capacity is used. Wait for a while and try again.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
867
P2X0-1210-05ENZ0