Set Nas-Multipath - Fujitsu Eternus DX100 S3 User Manual

Chapter 7 NAS Function Setting and Display
7.4 Network Interface Multipath Configuration > set nas-multipath

set nas-multipath

This parameter sets a multipath configuration for NAS ports.
■
Syntax
set nas-multipath -port
■ Parameter
-port
■ Example(s)
The following example shows the settings to set CM#0 CA#0 Port#1 and CM#1 CA#0 Port#1 as a pair:
CLI> set nas-multipath -port 001,101
port1 port2
,
This parameter specifies the ports that are paired in the multipath configuration. Insert a
comma (,) between each of the ports as a delimiter.
The following ports cannot be specified:
• Ports other than the NAS port
• Ports that are paired with another port
• Ports that are already specified as a member port
• Ports in the same CM
• Ports in different subnet addresses
port1 port2
, Ports that are to be paired
Example: -port 001,101
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
768
P2X0-1210-05ENZ0