Fujitsu Eternus DX100 S3 User Manual page 534

Chapter 5 System Settings and Display
5.2 Network Management > create community-profile
-manager-number
■
Example(s)
The following example sets the SNMP community. SNMP manager numbers 1 to 10 are specified, and the
SNMP MIB view name is "xview4":
CLI> create community-profile -community community1 -manager-number 1-10 -view xview4
The following example creates the SNMP community in which the SNMP community is named
"community2", the SNMP manager number is 2, and the SNMP MIB view is able to access all MIB views:
CLI> create community-profile -community community2 -manager-number 2 -view xview5
The following example creates an SNMP community that is used only for traps.
CLI> create community-profile -community community3 -manager-number 3 -view ""
The following example creates an SNMP community for which unlimited access is specified:
CLI> create community-profile -community community4 -manager-number none -view xview6
This parameter specifies the number of SNMP managers.
Any value between 1 and 10 can be specified. One or more numbers can be specified by
separating them with a comma (,) or a hyphen (-). This number can be confirmed by using the
"show snmp-manager" command. If unlimited access is specified for the community, specify
"none" instead of a manager number.
manager_numbers
SNMP manager number (1 – 10)
none Unlimited access is specified for the community.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
534
P2X0-1210-05ENZ0