Release Host-Affinity - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > release host-affinity

release host-affinity

This command releases the associated LUN groups from the host identifiers. This command cannot be used
when Host Affinity Mode is disabled for the host interface port.
■ Syntax
release host-affinity
{ -port { xyz
{-port-group-number
{-host-group-number
}
■ Parameter
-port
-host-number
or
-host-name
[-host-number host_numbers
port_group_number
host_group_number
This parameter specifies the host interface ports to be released. Two or more parameters can
be specified by separating them with a comma (,).
Example: -port 000,100
For details, refer to "1.2.15 Host Interface Port Syntax" (page
If this parameter is specified together with the host identifier, only the mapping definition for
the specified host identifiers is released.
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the host
port number.
Example: "123" indicates CM#1-CA#2- Host port#3
all All the host interface ports
The settings for all of the ports are released. When this parameter is specified,
the "-host-number" or "-host-name" parameter cannot be specified.
Optional. This parameter specifies the host identifiers that are released from the host identifi-
ers of the specified host interface port. One or more parameters can be specified at the same
time. If omitted, all definitions of the specified host interface ports are released.
host_numbers
Host number
host_names
Host name
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
| -host-name host_names ] | all} |
port_group_name
| -port-group-name
host_group_name
| -host-group-name
295
}
}
29).
P2X0-1210-05ENZ0