Fujitsu Eternus DX100 S3 User Manual page 321

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set port-group
-add-port
or
-release-port
■ Example(s)
The following example changes the port group named "PG001". The new name is "NEW_PG002":
CLI> set port-group -port-group-name PG001 -name NEW_PG002
The first command creates the port group named "PG0001". This port group contains FC interface port #1 on
CM#0 CA#0 and FC interface port #1 on CM#0 CA#1.
The second command adds other definitions to the port group named "PG0001". FC interface port #1 on
CM#1 CA#0 and FC interface port #1 on CM#1 CA#1 are added to the port group:
CLI> create port-group -port-group-name PG0001 -port 001,011
CLI> set port-group -port-group-name PG0001 -add-port 101,111
Optional. This parameter specifies the host interface port that is to be added or deleted. Two or
more parameters can be specified by separating them with a comma (,).
Example: -add-port 000, 011
For details, refer to "1.2.15 Host Interface Port Syntax" (page
ports
Host interface port number in "
"x" is the controller module (CM) number, "y" is the CA number, and "z" is the port
number.
Example: "123" indicates CM#1-CA#2-Port#3
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
xyz
" format
321
29).
P2X0-1210-05ENZ0